IEI Integration IBX-530B-N270 - Manual (Page 42)

IBX-530B-270 Embedded System
Page 30
4.1 Anti-static Precautions
WARNING:
If the following anti-static precautions are not followed, a user may be
injured and the system irreparably damaged.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the AFLMB-945GSE motherboard and the power module. (Dry climates are
especially susceptible to ESD.) It is therefore critical that whenever the IBX-530B-N270 is
opened and any electrical component handled, the following anti-static precautions are
strictly adhered to.
Wear an anti-static wristband: Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding: Before handling the board, touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
4.2 Installation Procedure
4.2.1 Installation Procedure Overview
To properly install the IBX-530B-N270, the following steps must be followed. Detailed
descriptions of these instructions are listed in the sections that follow.
Step 1: Unpacking
Step 2: Configure the jumper settings
Step 3: Install the CF card
Step 4: Install the four foot pads/Mount the IBX-530B-N270
Step 5: Connect the front panel peripheral connectors
Step 6: Power the system up Step 0: