IEI Integration IBX-530B-N270 - Manual (Page 33)

IBX-530B-270 Embedded System
Page 21
3.5.3 CF Card Setup
Jumper Label: JCF1
Jumper Type: 2-pin header
Jumper Settings: See Table 3-3
Jumper Location: See Figure 3-3
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in Table 3-3.
Setting Description
Open Slave Default
Closed Master
Table 3-3: CF Card Setup Jumper Settings
The CF Card Setup jumper location is shown in Figure 3-3.
Figure 3-3: CF Card Setup Jumper Location
3.5.4 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 2-pin header
Jumper Settings: See Table 3-4
Jumper Location: See Figure 3-4