IEI Integration AFL-4 series-N270 v1.05 - Manual (Page 45)

AFL-4 Series-N270 User Manual
Page 45
Anti-static Discharge: If a user open the rear panel of the flat panel PC, to
configure the jumpers or plug in added peripheral devices, ground themselves
first and wear and anti-static wristband.
4.3 Preinstalled Components
The following components are all preinstalled.
Motherboard
TFT LCD screen
1.0 GB DDR2 memory module
Resistive type touch screen
Wireless LAN module
Bluetooth module
AT/ATX power switch
Preinstalled customizations may include the following.
Different DDR2 memory module
Hard disk drive (AFL-412A/AFL-415A/AE only)
Component installation is described in the following sections.
4.4 Installation and Configuration Steps
The following installation steps must be followed.
Step 1: Unpack the flat panel PC
Step 2: Install a CF card
Step 3: Install a HDD (ALF-12A/AFL-415A/AE only)
Step 4: Configure the system
Step 5: Connect peripheral devices to the bottom panel of the flat panel PC
Step 6: Mount the flat panel PC
Step 7: Install faceplate onto the flat panel PC Step 0: