1 memory module replacement, Eplacing, Omponents – IEI Integration AFL-4 series-N270 v1.05 User Manual
Page 75: Figure 5-1: back cover retention screws, 5 replacing components
Advertising
AFL-4 Series-N270 User Manual
Page 75
Figure 5-1: Back Cover Retention Screws
Step 5:
Lift the cover off and pull down the cover a bit to make it possible to lift the cover
further more after removing the retention screws. More strength is required to
separate the cover from the chassis.
Step 0:
5.5 Replacing Components
5.5.1 Memory Module Replacement
The flat panel PC is preinstalled with a 1 GB DDR2 memory module. If the memory
module is fail, follow the instructions below to replace the memory module.
Step 1:
Remove the aluminum back cover. See Section 5.4.1 above.
Step 2:
Locate the DDR2 SO-DIMM on the motherboard (Figure 5-2).
Advertising