1 wall surface mounting, Figure 4-10: wall-mounting bracket – IEI Integration AFL-4 series-N270 v1.05 User Manual
Page 58
AFL-4 Series-N270 User Manual
Page 58
4.10.1 Wall Surface Mounting
To mount the flat panel PC onto the wall, please follow the steps below.
Step 1:
Select the location on the wall for the wall-mounting bracket.
Step 2:
Carefully mark the locations of the four screw holes in the bracket on the wall.
Step 3:
Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 4:
Align the wall-mounting bracket screw holes with the pilot holes.
Step 5:
Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (Figure 4-10).
Figure 4-10: Wall-mounting Bracket
Step 6:
Insert the four monitor mounting screws provided in the wall mounting kit into the
four screw holes on the real panel of the flat panel PC and tighten until the screw
shank is secured against the rear panel (Figure 4-11).
Step 7:
Align the mounting screws on the monitor rear panel with the mounting holes on
the bracket.