IEI Integration AFL2-12A-HM65 v1.12 - Manual (Page 69)

AFL2-12A-HM65 Series Panel PC
Page 55
Step 7: Grasp the DDR3 memory module by the edges and carefully pull it out of the
socket.
Step 8: Install the new DDR3 memory module by pushing it into the socket at an angle
(
6
Figure 5-3).
Step 9: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
6
Figure 5-3).
Step 10: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
Figure 5-3: DDR SO-DIMM Module Installation
Step 11: Replace the internal aluminum cover and secure it to the chassis using six (6)
retention screws.
Step 12: Replace the back cover and secure it using nine (9) previously removed
retention screws. Step 0:
5.5.2 WLAN Card Replacement
The AFL2-12A-HM65 has one WLAN card slot. To replace the WLAN card, follow the
instructions below.
Step 1: Follow all anti-static procedures. See Section
6
5.2.
Step 2: Turn off the power. See Section
6
5.3.
Step 3: Remove the back cover. See Section
6
5.4.1.