3 install drives, Figure 4-3: drive bracket retention screws – IEI Integration RPC-6106_6108 User Manual
Page 35
Advertising
RPC-6106/6108 Rackmount LCD Workstation
Figure 4-3: Drive Bracket Retention Screws
Step 2:
Remove the drive bracket from the chassis.
Step 0:
4.5.3 Install Drives
The drive bracket supports two 3.5” disk drives. To install disk drives, follow the
instructions below.
Step 1:
Remove the drive bracket from the RPC-6106/6108 Rackmount LCD
Workstation (see Section 4.5.3).
Step 2:
Slide the disk drive into the drive bracket. Make sure the signal connectors and
the power connector of the drive are facing the front of the bracket.
Step 3:
Insert the appropriate number of retention screws into each side of the disk drive
through the drive bracket.
Step 0:
Page 25
Advertising