IEI Integration RPC-6106_6108 - Manual (Page 43)

RPC-6106/6108 Rackmount LCD Workstation
4.5.8.2 PSU Cables
PSU cables must be connected to the following components (if installed):
CPU card
Backplane
HDD
Optical drive
4.5.8.3 Disk Drive Ribbon Cables
Disk drive ribbon cables must be connected to the corresponding CPU card disk drive
connectors.
4.5.8.4 RS-232 Cable (T-R Models Only)
To connect the RS-232 connector for using touch screen, please follow the steps below:
Step 1: Connect the RS-232 cable that comes with the RPC-6106/6108 to the RS-232
connector on the CPU card.
Step 2: Locate the other RS-232 cable on the AD board (Figure 4-11).
Figure 4-11: RS-232 Cable on the AD Board
Step 3: Connect these two RS-232 cables. Step 0:
Page 33