SaltDogg TGS Controller (3011864) - TGSUVPROA, TGS01B, TGS03, TGS05B, TGS06, TGS07 - Manual (Page 2)

TM
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
3019468 Rev. C
WARRANTY
Buyers Products Co. warrants all truck/trailer hardware manufactured or distributed by it, to be free from defects in material and work-
manship for a period of one year from date of shipment. Parts must be properly installed and used under normal conditions. Any
product which has been altered, including modification, misuse, accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of Buyers Products Co. under this warranty is limited to repairing or replacing any part
or parts which are returned, prepaid, and are found to be defective by Buyers Products Co. Authorization from Buyers Products Co. must be obtained
before returning any part. No charges for transportation or labor performed on Buyers’ products will be allowed under this warranty.
SPEED
DISPLAY
VIBRATOR
SWITCH
MOTOR, WIRE HARNESS,
CONTROLLER STATUS
ACTION
REQUIRED
1 Controller out of calibration Replace controller
2 E Internal error.
Turn controller OFF for 30 sec. Turn
controller ON. If reboot doesn't
work, replace.
3
L
Ignition wire connected to 12 VDC
source, positive harness wire is
disconnected from battery
Connect red wire to battery
4 Truck's battery is low. Check truck electrical system
5 F
Wire harness positive wire short to
truck's body/ frame. Motor internal
fuse (40 AMP) blown.
Find and eliminate short circuit.
Replace fuse.
6 H
Wire harness motor wires short to
each other (red to black).
Find and eliminate short circuit.
7 U
Short circuit in vibrator or in wire
harness connected to vibrator.
Outside fuse (30 AMP) is blown.
Vibrator disconnected.
Find and eliminate short circuit.
Replace fuse.
Connect vibrator.
8 Light blinking Internal vibrator fuse blown. Find and eliminate short.
9
Speed number
blinking, motor turns
slow or stopped. Motor is overloaded.
Motor wires in wire harness shorted
to each other.
Clear jam.
Find and eliminate short.
10 P No contact in spinner motor circuit. Find and correct broken connection.
11 C Controller temperature over 160F.
Turn OFF controller. Reposition
controller for better temperature
control.
Controller Codes
F