SaltDogg SHPE0750 Series Electric Drive Poly Hopper Spreader v.2 - Manual (Page 2)

2
Safety Precautions
WARNING
Observe the following Safety Precautions before, during and
after operating this spreader. By following these precautions
and common sense, possible injury to persons and potential
damage to this machine may be avoided.
1. Read this entire Owners Manual before operating this
spreader.
2. Read all safety decals on the spreader before operating.
3. Check to make sure all safety guards are securely mount-
ed into place before operating this spreader.
4. Verify that all personnel are clear of the spreader spray
area before starting or operating this spreader.
5. Do not overload your vehicle beyond payload
limits. If there are any questions, contact the vehicle
manufacturer.
6. Do not adjust, clean, lubricate or unclog material jams
without first turning off the spreader.
7. Do not climb on or in the spreader during operation.
8. Do not ride on the spreader while the vehicle is in motion.
9. Make sure the spreader is securely fastened to the vehicle
in accordance with this manual.
10. Do not operate a spreader that is in need of maintenance
or repairs.
11. Always disconnect the battery before removing or
replacing electrical components.
Installation Instructions
1. Mounting the Spreader onto the Vehicle
A. Remove the tailgate from the vehicle.
B. Check the truck bed for any sharp debris or foreign
objects. These can cut and seriously damage poly
hopper.
Use All Tiedowns to Lift the Spreader
Fig. 1
Fabricate and Insert
Spacer As Shown
Fig. 2
30° - 45°
Vertical
15.0° - 35° Horizontal
Fig. 3
C. Lift spreader using tie downs. See (Fig. 1)
D. Slide spreader forward in truck bed until the steps on
rear legs of the spreader make contact with truck’s bed.
Measure the distance from the front of the truck bed to
front of the hopper's front legs. Fabricate spacer to fit
between front of the spreader and front of the bed per
Fig. 2.
E. Center the spreader from side to side on the vehicle.
Securely strap the spreader to the truck using four
ratchet straps as shown. (Fig. 3) Front straps must be
attached to anchor points located in front of the spread-
er to create longitudinal stability for the spreader.
Rear straps must be tightened evenly to secure the
spreader in the middle of the truck. Criss-cross straps
can be used.
Verify with the vehicle’s manufacturer that the factory
installed anchor points are designed for tie-down of such
load. Inspect straps and hardware after each time spreader
is loaded. Tighten straps and hardware if necessary.