SaltDogg TGS03YEL Salt Spreader - Manual (Page 5)

5
BATTERY
CONTROLLER
PART #3008623
POWER CABLE
PART #3008615
WIRE HARNESS
PART #3008620
FUSE CONNECTOR
CONNECTOR TO FUSE TERMINAL
OR IGNITION SWITCH
2-PIN CONNECTOR
4-PIN CONNECTOR
GEAR MOTOR
PART #3015377
Installing Controller and Wiring
• Route both wire harnesses into truck cab through
firewall (it maybe necessary to drill holes). Insulate hole
to avoid water leaks.
• Insure no wires are nicked or damaged during
installation.
• Connect the 4-pin connecter on the wire harness to
the control box.
• Connect the 2-pin connector on the power cable to the
control box.
• Connect fuse connector to the fuse terminal or ignition
switch.
• Lay out a path for the power cable to the battery, use
quick ties to secure power cable. DO NOT CONNECT TO BATTERY AT THIS TIME!
• Lay out path for wire harness to the rear of the vehicle.
It is recommended to stay clear of the exhaust system.
Excess heat can damage the wire harnesses. Use quick
ties to secure harness to underbody.
• Connect the wire harness to the motor and vibrator.
• Connect the power and ground cables directly to the
battery.
• Insure all functions of the controller are working
properly.
• Note: direction of spinner may be changed by inter-
changing the motor leads.
THIS IS WIRE GROUND ELECTRICAL SYSTEM!
NO CONNECTIONS TO TRUCK’S FRAME OR BODY
ALLOWED!
NOTE: Always disconnect battery before attempting
to install electrical components on your vehicle.
Mount the controller in a convenient location
in the truck cab. It is recommended not to mount the
controller directly in front of heat vents. Allow ample
air space around controller.
CAUTION
DO NOT MOUNT CONTROLLER IN THE WAY OF AIR
BAG DEPLOYMENT!