SaltDogg SHPE2000 Series Electric Drive Poly Hopper Spreader v.2 - Manual (Page 3)

3
TM
To insure good performance of your spreader, check the
condition of truck’s electrical system. Using digital voltmeter,
check alternator and battery voltage. With engine running
and head lights and heater fan on good voltage reading
should fall between 13.0 and 15.3 volts. If voltage reading
falls out of this range, check and adjust your electric system.
H. Secure spreader using four retched straps as shown
in Fig. 6. Tighten straps evenly to secure spreader in the
middle of the truck box.
15
8
2" x 4"
2" x 6"
FIT TO BOX
FIT TO BOX
Fig. 4
Fig. 5
Verify with the vehicle’s manufacturer that the factory
installed anchor points are designed for tie-down such
load. Inspect straps and hardware after each time spreader
is loaded. Tighten straps and hardware if necessary.
Fig. 6
2. Control Box and Vehicle Wiring Harness Installation
WARNING
Do not drill holes into fuel tanks, fuel lines, through electrical
wiring, etc that may be damaged by drilling.
WARNING
Use extreme caution when working around an operating
vehicle engine.
WARNING
Do not install controller in the deployment path of an air
bag.Refer to vehicle manufacturer’s manual for air bag
deployment area(s).
A. Lay out a wiring path for the Vehicle Wiring Harness.
Connect the Wire Harness smaller terminal to the Chute’s
harness, large terminal to the Hopper’s harness. Drill all
necessary holes or use existing ones to pass the round
terminal into the trucks cab. Attach harness to truck’s frame.
B. Mount the Controller in a convenient location in the truck
cab. It is recommended not to mount Controller directly in
front of the heat vents.
C. Connect the Wire Harness round terminal to the
Controller round terminal.
D. Lay out path for the Power Cable in the truck’s engine
compartment. Drill hole in the firewall or use an existing one
to pass wire harness. It is recommended to pass the Power
Cable from inside of the cab to the battery due to the large
high amperage connector. Do not route close to exhaust
system!
E. Connect Power Cable terminal to Controller.
F. Connect the Power Cable ring terminals to the truck’s
battery, white-positive, and black-negative.
G. Make sure that the Controller is OFF. Connect blue wire’s
small female terminal to Controller’s Ignition wire. Connect
the blue wire from the Controller to an accessory wire/
terminal that is controlled by the vehicle’s ignition switch
(See Fig. 7).
Spreader Operation
1. SHPE2000 spreader is equipped with a dual independent
speed Controller with warning lights and a Vibrator switch.
To start the spreader, press the ON-OFF switch. Switch will
illuminate. The auger will accelerate to full speed for 2 sec.,