SaltDogg SHPE4000 Series Electric Drive Poly Hopper Spreader - Manual (Page 2)

2
TM
37.5" 25.5"
48.0"
24.0"
Fig. 2
D. Lower spreader into the truck bed. Attach chute to the
spreader. If necessary, slide spreader rearward to have
at least 1" clearance between chute and rearmost vertical
obstruction.
E. Make sure the spreader is centered from side to side and
rear gussets rest fully on trucks body.
F. Using holes in gussets as templates transfer six (6) holes
positions on trucks bed. Make sure that these holes will not
interferes with any important trucks components. Drill six
9/16" holes. Dimensions between holes are shown in Fig.2.
Bolt spreader to the vehicle. Using 1/2" grade 5 hardware.
Fig. 3
G. Attach tie-down hooks to the hopper. Secure spreader
using four ratchet straps as shown. Tighten straps evenly to
secure spreader in the middle of the truck box (Fig.3).
Inspect straps and hardware after each time spreader is
loaded. Tighten straps and hardware if necessary.
WARNING
Do not drill holes into fuel tanks, fuel lines, through
electrical wiring, etc that may be damaged by drilling.
WARNING
Important! Do not use ratchet straps exclusively!
Always bolt spreader to the vechicle.
WARNING
Must bolt down each gusset using
one of the two holes provided