SaltDogg 1400701SS Self-Contained Stainless Steel Hopper Spreaders - Manual (Page 4)

44
TM
B. Route both wire harnesses into truck cab through firewall
(it maybe necessary to drill holes). Insulate hole to avoid
water leaks.
C. Insure no wires are nicked or damaged during
installation.
D. Connect the 4-pin connector on the wire harness to the
control box 4-pin connector.
E. Connect the 2-pin connector on the power cable to the
control box mating connector.
F. Connect wire harness single connectors to control box
connectors.
G. Connect fuse connector to the fuse terminal or ignition
switch (5 AMP max).
H. Lay out a path for the power cable to the battery, use
quick ties to secure power cable.
DO NOT CONNECT TO BATTERY AT THIS TIME!
I. Lay out path for wire harness to the rear of the vehicle. It
is recommended to stay clear of the exhaust system. Excess
heat can damage the wire harnesses. Use quick ties to
secure harness to underbody.
J. Connect the wire harness to the motor. Make sure wire
colors on wire harness match colors on the motor.
IMPORTANT
IMPORTANT Make sure all wires securely attached to
vehicle or spreader. Use wire ties and/or wire clamps
to attach wires. All excess wires must be rolled into
bungles and attached to vehicle or spreader.
CONNECT WIRE HARNESS
TO COLOR CODED TERMINALS
SECURE WIRE HARNESS
ON SPREADER USING CLAMP HK1113
AND NUT 1/4-20
ROUTE WIRE HARNESS
THRU OPENING IN COVER
Thoroughly clean battery terminals. Make sure battery
terminals have no tarnish or corrosion. DO NOT CONNECT
WIRE HARNESS TO DAMAGED OR CORRODED
TERMINALS!
IT MAY RESULT IN OVERHEATING, LOST POWER AND
POTENTIAL CONTROLLER DAMAGE!
K. Connect the power cable directly to the battery.
L. Insure all functions of the controller are
working properly.
M. Observe chain moving in proper direction. If direction is
wrong reverse wires between Motor and Wire Harness.
N. Optional spot light (5 AMP max) can be installed on
spreader. Remove cap from single white wire. Connect light
to this wire and trucks frame.