Watlow EZ-ZONE RM Limit Module Rev C - Manual (Page 108)

Watlow EZ-ZONE ® RML Module • 105 • Chapter 6 Features
Timer Function
An error, when read, can indicate any of the following:
None, Open, Shorted, Measurement Error, Bad Cal Data,
Ambient Error, RTD Error, Fail, Math Error, Not Sourced,
Stale
Timer
Overview
Instances - 16 per RML
Function
Source
Active State
A
Source
Active State B
Source Function A
Source Instance A
Source Zone A
Source Error A
Source Function B
Source Instance B
Source Zone B
Source Error B
Time
Active Level
Output Value
Error
Source Value A
Source Value B
Elapsed Time
[``Fn] Function : Off, On Pulse, Delay, One Shot, Retentive
[`S2;A] Source Zone A : 0 to 16
[`S2;b] Source Zone B : 0 to 16
[`Si;A] Source Instance A : 1 to 250
[`Si;b] Source Instance B : 1 to 250
[`Su;A] Source Value A : Off, On
`[Su;b] Source Value B : Off, On
[``o;u] Output Value : Off, On
[``E;t] Elapsed Time : 0.0 to 9,999.000 seconds
[``ti] Time : 0 to 9,999 seconds
[tMr] Timer Menu
[`SEt] Setup Page
[SAS;A] Source Active State A (Timer Run) : High (rising), Low (falling)
[SAS;b] Source Active State B (Timer Reset) : High (rising), Low (falling)
[`LEu] Active Level : High, Low
[tMr] Timer Menu
[oPEr] Operation Page
[sfn;a] Source Function A (Timer Run) : None, Alarm, Compare,
Counter, Digital I/O, Profile Event Out A to H, Function
Key, Logic, Special Function Output 1 to 4, Variable
[sfn;b] Source Function B (Timer Reset) : None, Alarm, Compare,
Counter, Digital I/O, Profile Event Out A to H, Function
Key, Logic, Special Function Output 1 to 4, Timer,
Variable
Timer
Off
Function
Source
Active State
A
Source
Active State B
Source Function A
Source Instance A
Source Zone A
Source Error A
Source Function B
Source Instance B
Source Zone B
Source Error B
Time
Active Level
Output Value
Error
Source Value A
Source Value B
Elapsed Time
Output Value = OFF