Yokogawa EJX118A - Manual (Page 51)

<8. General Specifications>
8-9
IM 01C25H01-01E
The “►” marks indicate the most typical selection for each specification. Example: EJX118A-DMSCG-912EN-WA13B1SW00-BA25/
*1: See table 8.3 ‘Gasket contact surface’ on page 8-4.
*2: When specified flushing connection ring code 1, 2, A, or B, exclusive gasket is provided for transmitter side.
*3: In case of wetted parts material code TW (Tantalum), the process temperature limit is –10 to 200°C.
*4: Wetted parts material code TW (Tantalum) cannot be applied.
*5: Even in case where fill fluid code D (fluorinated oil) is selected, if degrease cleansing treatment or both degrease cleansing and
dehydrating treatment for the wetted parts is required, specify option code K1 or K5.
*6: In case of wetted parts material code HW (Hastelloy C), TW (Tantalum), and UW (Titanuym) for 2-inch pressure flange, specify
capillary length from 1 to 5 m.
*7: Flushing connection ring code 1, 2, A, or B cannot be applied.
*8: Not applicable for gasket contact surface code 1.
*9: Hastelloy C-276 or N10276.
*10: Forged version of the material may be used.
*11: Not applicable for wetted parts material code UW (Titanium).
*12: The upper ambient temperature limit is 50°C (122°F) in the following combinations.
Process connection style code Process connection size code
W (Flush type) 2 (2-inch) or 8 (1 1/2-inch)
E (Extension type) 3 (3-inch)
The “#” marks indicate the construction materials conform to NACE material recommendations per MR01-75. For the use of 316 SST
material, there may be certain limitations for pressure and temperature. Please refer to NACE standards for details.