Yokogawa SPS24 - Manual (Page 14)

<2. Preparation and Basic Operation>
2-4
IM 12A01S02-01E 1st Edition : May 10, 2013-00
3. “License Agreement” appears. Read the terms on the license agreement. Select “I accept
the terms in the License Agreement” and click “Next”.
(Selecting “I do not accept the terms in the License Agreement” aborts SPS4 installation.
Click “Cancel” to leave the installation.)
4. The “User information” screen is displayed. Enter the user name and organization, and click
“Next”.
5. The “Install destination” screen appears.
If you need to change the install destination, enter the desired location and click “Next”.
6. The “Ready to install” message appears. Click “Install”.
7. Installation begins. When installation completes successfully, the “Setup Complete” dialog
appears. Click “Finish” to continue.
SPS24 installation is complete.
2.3 Confirming Installation and Uninstallation
The procedure to confirm installation or uninstall drivers and SPS24 is as follows.
NOTE
To uninstall the USB driver, first disconnect the USB cable from the computer.
NOTE
To uninstall the SPS24, [Export] in Database viewer and Setup beforehand, and save the sensor
information.
Go to Windows [Start] – [Control Panel] – [Programs and Features] ([Add or Remove Programs]
in Windows XP).
For the driver, confirm that “Yokogawa Driver for interface box” is listed. For the SPS24, confirm
that “Yokogawa SENCOM PC Software” is listed.
To uninstall the driver or software, right-click on the desired listing and click “Uninstall”.
In the case of Windows XP, click “Delete”.
SPS24 can be confirmed by using the following method.
Go to Windows [Start] – [All Programs] to confirm that [Yokogawa SENCOM PC Software] is
listed.
Clicking “SENCOM PC Software” launches SPS24.
Clicking on “User’s Manual” opens this document (IM 12A01S02-01E) in PDF format.