Yokogawa SC72 Personal Handheld Conductivity Meter - Manual (Page 16)

IM 12D03D02-01E
2-3
2. Preparation
2.3 Setting Date and Time
After installing the batteries, set the date and time. Note that if the power is turned off
before setting “minutes,” start with the date setting when you turn on the power next
time.
If you replace the batteries, the date is not affected, but the time is reset. Reenter the
time.
Caution: If the sensor is not connected then an error will be displayed on the meter.
• Setting method
After installing batteries, press and hold the POWER key for at least one second. Then
all display elements turn on and the date setting display automatically appears. Set year,
month, day, hours, and minutes as follows:
Caution: If you stop part way through the date and time setting then the meter will beep
and the date and time will not be updated.
F020301.EPS
key for at least 1 sec.
After
pressing
to set
to confirm
to set
to set
to confirm
to confirm
to set
to confirm
Year setting
Day setting Hour setting (24-hour format)
Month setting
Minute setting
After
several
seconds
After
several
seconds
POWER
F/ENT
F/ENT F/ENT
F/ENT
to set to confirm
or
F/ENT