Yokogawa SC72 Personal Handheld Conductivity Meter - Manual (Page 29)

IM 12D03D02-01E 4-4
4. Keyswitch Functions
4.2 Liquid Crystal Display and Display Items
Displays and their explanations are shown below.
F040201.EPS
Remaining battery life display
Manual range setting mode
Temp. compensation setting mode
Data save mode
HOLD mode
Calibration with std. solution
Cell constant set mode
(1) Remaining battery life display
Remaining battery life is always displayed stepwise. When display is , battery is
normal. When a flashing is displayed, battery power is low. Replace the
batteries immediately if the above flashing battery symbol appears. Press POWER and
confirm that display turns off, then refer to Sec. 2.1 for battery replacement procedure.
(2) Temperature compensation setting mode
This mark appears when temperature compensation is being set (refer to Temperature
compensation setting (t.Co) panel in Section 4.3 (2))
(3) Manual range setting mode
Normally autoranging is used, and optimum range is selected automatically, but if fixed
(manual) range setting is used then this mark appears (refer to Range selection (rnG)
panel in Section 4.3 (3)).
(4) Data save mode
This mark appears when measured data are stored or when already-stored data are
accessed (see Operation of DATA key in Section 4.1, or Display stored measurement
value in Section 4.3 (1)).
(5) HOLD mode
This mark appears while measured data are being temporarily held (refer to Operation of
HOLD key in Section 4.1).
(6) Calibration with standard solution
This mode display appears when the calibration with standard solution is conducted
(refer to Calibration with standard solution (CAL) panel in Section 4.3 (5)).
(7) Cell constant set mode
This mode display appears when the sensor cell constants are manually set (refer to Cell
constant setting (C.C) panel in Section 4.3 (4)).