Yokogawa Value Series FX1000 - Manual (Page 83)

2-70
IM 04L21B01-64EN
Header
The header contains the title, protocol number, date, and signature.
Setup File
• Settings
Item Description
File Name The name of the setup file that is being edited. The full path is printed. The
name of a newly created file is “NewFile.”
Setting Number Not used. A diagonal line is drawn through this cell.
File Date Not used. A diagonal line is drawn through this cell.
• Changed Value
The last file name, setting number, and file date that were loaded when you selected
[Load Changed Settings].
Specified Values and Changed Values
There are specified value and changed value columns for the system configuration and
setup items. The setting values are the values at the time when one of the following
operations was last performed (the same as the settings that are recovered when you
select [File] - [Restore Original]).
• [File] - [New]
• [File] - [Open]
• [File] - [Save]
• [File] - [Save As]
• [Comm.] - [Receive Setting]
• [Comm.] - [Send Setting]
• [Comm.] - [Partial Transfer]
• [System] - [System Configuration]
The changed values are the last values that have been set for each item. If a value has
not been changed, a diagonal line is drawn through its cell.
Note
Items that cannot be set are not printed. Also, an item whose “Specified Value” is not printed is
not printed even if the settings are changed so that it can be set.
Example: When [Data Kind] is set to [Display], [Scan Interval] and [Data Length], which are
event data settings, are not printed. Even if you change [Data Kind] to [Event] and set
[Scan Interval] and [Data Length], these items are not printed.
System Configuration
The system configuration of the setup file. The device name, firmware version number,
and options are printed.
Setup Items
The settings for each setup item.
Footer
The page number.
2.9 Printing Setup Data