Yokogawa PC-Based MX100 - Manual (Page 16)

2-3
IM MW180-01E
Address Setting Software
1
2
3
4
5
App
Index
2.2 Setting Item Details
Procedure
Before carrying out the procedure below, turn ON the power to the relevant MW100s and
connect the MW100s to the network using Ethernet cables. When connecting the MW100
to the network, make the connection after changing the factory default IP address (see
“Opening a Local (1-to-1) Connection between the PC and MW100 and Changing the
Address”).
Opening a Local (1-to-1) Connection between the PC and MW100 and Changing
the Address
The MW100 cannot perform communication using the factory default IP address. Create
a local (1-to-1) connection between the MW100 and the PC on which the Address Setting
software is installed, or the PC on which the Address Setting software CD-ROM has
been inserted, and change the IP address.
The procedure for changing the address is as follows.
Changing the Address of the MW100 Connected to the Network
1. Start the Address Setting software.
The Address Setting screen in displayed.
2. Click the Search button in the List Display Screen.
The MW100s residing in the same segment are displayed.
3. Click the number of the MW100 whose address you wish to change.
The information of the selected MW100 is shown in blue characters.
4. Click Network Settings in the address setting change screen.
This enables changes to the settings.
5. Enter settings for each item.
6. Click Change to apply the changed settings to the MW100, Cancel to exit without
saving changes, or Clear to clear the IP address from the DHCP server.
2 4
3
5
6
Note
If your OS is Windows XP, Windows Vista, or Windows 7 and the firewall is enabled, it may not
be recognized even if you click the Search button. To solve the problem, see appendix 1 (this
phenomenon may also occur with some third party anti-virus programs).