Yokogawa PC-Based MX100 - Manual (Page 51)

4-2
IM MW180-01E
When the connection is established, information about the unit’s module
configuration is displayed.
To disconnect the connected
MW100
To illuminate the 7-segment
LED of the connected
MW100 to see which MW100
is connected
Information about the connected MW100
Modules attached to
the connected MW100
Data Acquisition Unit
If the specified IP address or host name is not correct, or the MW100 is connected
by another software program, the following dialog box opens.
Note
• You cannot change the MW100 network settings using the Calibrator. Use the Address
Setting Software (MW100 Viewer Software) to change the IP address and other settings.
• If you change the module configuration before connecting with the Calibrator or if modules
that are not operating properly exist, X marks are displayed on the modules as shown
below. If you change the module configuration, reconfigure the system using the browser.
• If your OS is Windows XP, Windows Vista, or Windows 7 and the firewall is enabled, it may
not be recognized even if you click the Search button. To solve the problem, see appendix 1
(this phenomenon may also occur with some third party anti-virus programs).
4.1 Connecting the MW100 Data Acquisition Unit