Yokogawa PC-Based MX100 - Manual (Page 14)

14
IM MX100-0E
Functions of the MX100 Standard Software
The MX100 Standard Software consists of the three software programs below.
Integration Monitor
Enables you to connect or disconnect communications, configure acquisition conditions
and display conditions of the measured channels, set up computations, monitor
measured and computed data, save measured and computed data, and carry out other
operations.
Viewer
Enables you to display measured and computed data that has been saved, read
values and perform statistical computation over an area using cursors, and convert the
measured and computed data into various file formats such as Excel.
Calibrator
This program is used to calibrate the input modules and output modules of the MX100.
This operation guide does not cover the operating procedures of the software. See the
MX100 Standard Software User’s Manual (IM MX180-01E).
Function Introduction