Yokogawa PC-Based MX100 - Manual (Page 37)


IM MX100-0E
Changing the Display Conditions
Click Display on the Monitor bar. You can change the display conditions on the Display
setup screen that opens. The automatic channel assignment function is convenient
for assigning all the channels that were specified to be monitored in “Setting the
Measurement Conditions” on page 32 to the display groups.
Channel display color
Trip point
Display zone position
Maximum/Minimum value of the scale
Select the display format of the Y-axis
(normal/exponent)
Select the Y-axis type (linear/logarithmic)
Turn scale ON/OFF when displaying
multi-axes zone
Channel select button
Display ON/OFF
Switch the display group
Group name
Execute automatic channel assignment
Number of channels assigned automatically
Restore the default maximum and minimum
values of the entire scale
Turn ON/OFF the trip point display
Click
To not copy
To copy
Reset to default When making the
settings the same
as the first item
Assign channels automatically
Turn ON/OFF collectively
Display Groups and Group Names
The Monitor screen displays waveforms or numeric values by dividing the channels into
groups. The measured/computed values can be divided into up to 10 groups. Up to 32
channels can be registered to a single group.
The channels that can be registered are those whose Monitor check boxes are selected
on the Channel setup screen. When you click a channel selection button on the Display
setup screen, the channel numbers of the channels that can be registered are displayed
(see the figure below). You can also select the channel by tag number or tag comment by
switching the tab.
You can enter a group name using up to 30 characters. By default, group names Group 1
to Group 10 are assigned.
Operations of the MX100 Standard Software