Yokogawa PC-Based MX100 - Manual (Page 38)


IM MX100-0E
Selecting the Display Zone of the Trend Waveform
You can select from the following. Taking the bottom and top edges of the waveform
display area to be 0% and 100%, respectively, set the waveform display position by
specifying the minimum value (0 to 99%) and the maximum value (1 to 100%).
• User zone
Displays each waveform at the position specified by Zone on the Display setup
screen. A single Y-axis scale of the active waveform can be displayed.
Select user zone
Click the bar to specify the
active Y-axis.
Display only the active Y-axis
Indicates the active Y-axis bar
Set the display zone
• Edit zone
Like the user zone, each waveform is displayed at the position specified by Zone on
the Display setup screen. However, you can change the zone on the Monitor screen.
A single Y-axis scale of the active waveform can be displayed.
Select edit zone
Drag the knob to change the minimum/maximum
value of the zone separately
Drag the bar to change the zone position
without changing the zone width
• Full zone
Displays all the waveforms over the full zone of the waveform display area regardless
of the Zone settings on the Display setup screen. A single Y-axis scale of the active
waveform can be displayed.
Select full zone
Waveform display area
(Full zone)
• Slide zone
Displays the waveforms by slightly offsetting the display position of each waveform
vertically regardless of the Zone settings on the Display setup screen. A single Y-axis
scale of the active waveform can be displayed.
Select slide zone
Slide in this manner
Operations of the MX100 Standard Software