Yokogawa PC-Based MX100 - Manual (Page 32)


IM MX100-0E
Setting Measurement Conditions
Click Channel on the Monitor bar to display the Channel setup screen. Click the Meas.
Channel tab.
Set the items other than input mode and measurement range as necessary. For a
description of setting alarms on measurement channels, see page 42. For a description
of setting DO channels, see page 44. For a description of setting up computation
channels, see page 46. For details about other channel settings, see the MX100
Standard Software User’s Manual (IM MX180-01E).
* Cannot be used when Mode is set to RRJC
Channel number
Select to record, or clear to not record
Select to monitor, or clear to not monitor
Select the input mode
Select the measurement range
Minimum/Maximum value of span
Check here to perform scaling*
Decimal point position of the scale
Select the reference channel for
differential input*
Check here to measure the differential
input (difference with respect to the
measured value of the reference
channel)*
Maximum/Minimum values of the scale*
Click Measurement channel tab
Icon of the attached module
Click the icon to select the channels
settings of the module.
Select the reference channel for the
remote RJC (valid only when the input
mode is set to RRJC (TC))
For instructions on these buttons, see the
explanation under “Changing the Display
Conditions” on page 37.
Unit (up to six characters, only when the
Use check box of Scale is selected)
Point to the icon to display
information about the module
Enter the tag comment
(up to 30 characters)
Enter the tag number
(up to 15 characters)
Set the time constant of the first-order
lag filter (when the input mode is set
to something other than DI)
Set the burnout (valid only when the
input mode is set to TC)
Set the RJC (valid only when the input
mode is set to TC)
Operations of the MX100 Standard Software