Yokogawa PC-Based MX100 - Manual (Page 39)

9
IM MX100-0E
• Auto zone
Displays the trend waveforms by dividing the waveform display area evenly according
to the number of displayed waveforms regardless of the Zone settings on the Display
setup screen.
Select auto zone
Divide evenly automatically
• Multi-axes zone
All the Y-axis scales of the displayed waveforms are aligned horizontally. To hide a
Y-axis scale, clear the Y-Axis check box on the Display setup screen. The display
zone is set to the position specified by Zone on the Display setup screen.
Turn OFF the Y-axis
display of Ch00002
The Y-axis of Ch00002
is not displayed.
Select multi-axes zone
Click the bar to
move the active
Y-axis to the left end
Indicates the active
Y-axis bar
Trip Point
You can display a trip line to indicate a particular value of interest (trip point) in the
waveform display area. Two trip points (trip 1 is red, trip 2 is blue) can be set on each
waveform. The trip line of the waveform corresponding to the left-most Y-axis is shown in
the waveform display area.
Turn ON the trip
line display
Trip 1 value
Trip 2 value Trip line
Trip 1 value
Trip 2 value
Y-axis bar at the
left end
Clipping of Trend Waveforms
By default (clip OFF), the waveform is not displayed when the measured/computed value
exceeds the minimum/maximum value of the scale (see the lower left figure). When clip
is turned ON, values that are smaller than the minimum value of the scale are displayed
as the minimum value and the values that are larger than the maximum value of the
scale are displayed as the maximum value.
Clip OFF Clip ON
Operations of the MX100 Standard Software