Yokogawa DAQWORX - Manual (Page 59)

2-48 IM WX11-01E
2.20 Creatng Numerc Out Wndows
You can create an object for editing output values and sending them to hosts whose
types are set to I/O Channel in the Channel Detail Setting dialog box.
You can only assign output channels.
Procedure
Creatng a New Object
1. Click the Numerc Out icon under Objects in the EDIT page of the operation
panel, or click the Numerc Out button in the object bar.
2. Move the mouse cursor to a location in the editing area where you want to place
one corner of the numeric out object.
3. Drag the cursor to the location of the opposite corner of the object.
A numeric out object is created in the two opposing corners defined in steps 2 and 3.
4. In the Setting Plate of the CHANNEL page in the operation panel, move the
cursor to the output channel that you wish to assign to the numeric out object.
5. Drag the OUTPUT CHANNNEL you wish to assign over the numeric out object
created in step 3.
The specified output channel is now assigned to the numeric out object.
Note
• When you move the output channel over the numeric out object, the cursor changes to .
Note that the output channel cannot be assigned when displayed as .
• You can only assign output channels to numeric out objects.
• To delete the output channel assignment from the numeric out object, see section 2.30,
“Editing Objects.”
• If no channels are linked to the output channel, it cannot be assigned.