Mammoth V-Cube Slim Split F-Series Sizes 830 and 840 User Manual
Page 9
Mammoth V-Cube Slim Split IOM, MAMM-VCS-IOM-3FA (September 2013) 9
CAUTION! DO NOT lift the fan cells by the
motor eye bolts or by attaching eye bolts to
the motor mount plates. This may result in
personal injury, equipment damage or motor/
wheel misalignment.
2. As a safety precaution, take up the slack in the lifting
straps before removing any connecting bolts from the
section.
3. Remove the screws from the access panel on the
front of the FANWALL section, then remove the
panel. See Figure 9.
4. Remove the screws from the sound attenuation
panel, then remove the panel. See Figure 10.
5. Remove the three fasteners that attach the front, coil
side of the FANWALL section to the base as shown in
Figure 9: FANWALL Removal From Front
Section
fasteners
Access
panel
Sound attenuation panel
Loop lifting straps
around the motor
mount frames
6. Remove the access panel from the back of the base
cabinet section as shown in Figure 9.
7. Remove the seven fasteners (three on the front, two
on each end) connecting the FANWALL section to the
main chassis as shown in Figure 10.
Figure 10: FANWALL Removal from Rear
Section
fasteners
8. Carefully lift the FANWALL section off the base with
the attached lifting straps.
CAUTION! This method of lifting may be
imbalanced. Use care to avoid personal injury
or damage to the FANWALL section.
IMPORTANT! The gasket between the FAN-
WALL section and the main chassis must be
replaced before reassembling the section.
Failure to do so may cause air leakage and
poor unit performance.