Brocade FastIron GS and GS-STK Hardware Installation Guide - Manual (Page 102)

92 Brocade FastIron GS and GS-STK Hardware Installation Guide
53-1002186-02
Installing or replacing a POE daughter card
8
DRAFT: BROCADE CONFIDENTIAL
Disassembling the device
This section provides instructions for disassembling the device so that you can install, remove, or
replace a POE daughter card.
1. Remove power to the Brocade device. For AC power supplies, turn the switch to the OFF
position. For DC power supplies, turn off the DC power source or disconnect the cables from
the power supply.
2. Put on an Electrostatic Discharge (ESD) wrist strap and attach the clip end to a metal surface
(such as an equipment rack) to act as ground.
3. Remove the device cover and faceplate:
• If the device was mounted in a rack, remove the two mounting brackets from the device.
Figure 29 on page 32 shows the location of the mounting brackets and screws.
• Use a #2 Phillips-head screwdriver to remove the two screws on each side of the cover.
(There are four screws altogether as shown in
Figure 56 .)
FIGURE 56 Removing the Screws for the Top Cover
• Gently slide the cover towards the back of the unit and lift it off of the device as shown in
Figure 57 .
FGS-2XG