Installation precautions, General precautions, Lifting precautions – Brocade FastIron GS and GS-STK Hardware Installation Guide User Manual
Page 29
Brocade FastIron GS and GS-STK Hardware Installation Guide
19
53-1002186-02
Installation precautions
2
DRAFT: BROCADE CONFIDENTIAL
Installation precautions
Follow these precautions when installing a Brocade device.
General precautions
DANGER
All fiber-optic interfaces use Class 1 lasers.
CAUTION
Do not install the device in an environment where the operating ambient temperature might
exceed 40
C (104
F).
CAUTION
Make sure that air flow around the front, sides, and back of the device is not restricted.
CAUTION
Never leavec tools inside the device.
Lifting precautions
DANGER
Make sure the rack or cabinet housing the device is adequately secured to prevent it from
becoming unstable or falling over.
DANGER
Do not use the handles on the power supply units to lift or carry a Brocade device.
DANGER
Mount the devices you install in a rack or cabinet as low as possible. Place the heaviest device at
the bottom and progressively place lighter devices above.