Brocade FastIron GS and GS-STK Hardware Installation Guide - Manual (Page 32)

22 Brocade FastIron GS and GS-STK Hardware Installation Guide
53-1002186-02
Installation precautions
2
DRAFT: BROCADE CONFIDENTIAL
CAUTION
The FGS power supply is designed exclusively for use with the FGS devices. The power supply
produces extensive power to support 802.3af applications. Installing the power supply in a
device other than the FGS will cause extensive damage to your equipment.
DANGER
Disconnect the power cord from all power sources to completely remove power from the device.
DANGER
Make sure to choose the appropriate circuit device depending on the number of AC power
supplies installed in the device. The minimum current draw for the system is one AC power
supply.
DANGER
Power supplies are hot swappable. However, Brocade recommends that you disconnect the
power supply from AC power before installing or removing the supply. The device can be running
while a power supply is being installed or removed, but the power supply itself should not be
connected to a power source. Otherwise, you could be injured or the power supply or other parts
of the device could be damaged.
DANGER
Make sure that the power source circuits are properly grounded, then use the power cord
supplied with the device to connect it to the power source.
DANGER
If the installation requires a different power cord than the one supplied with the device, make
sure you use a power cord displaying the mark of the safety agency that defines the regulations
for power cords in your country. The mark is your assurance that the power cord can be used
safely with the device.