Brocade FastIron GS and GS-STK Hardware Installation Guide - Manual (Page 40)

30 Brocade FastIron GS and GS-STK Hardware Installation Guide
53-1002186-02
Installing the device
2
DRAFT: BROCADE CONFIDENTIAL
FIGURE 26 Connecting the wires to a DC power supply
10. Tug gently on each wire to make sure it is securely fastened in the connector.
11. Replace the power supply locking screw.
Installing the device
You can install Brocade devices on a desktop or in an equipment rack.
DANGER
Make sure the rack or cabinet housing the device is adequately secured to prevent it from
becoming unstable or falling over.
DANGER
Mount devices in a rack or cabinet as low as possible. Place the heaviest device at the bottom
and progressively lighter devices above.
Desktop installation
1. Set the device on a flat desktop, table, or shelf. Make sure that adequate ventilation is
provided for the system – a 3-in. clearance is recommended on each side.
2. Proceed to “Powering on the system” on page 35.
Rack mount installation
For rack mount installation, Brocade recommends that you use a Telco equipment rack.
1 Ground
2 Power supply locking screw
+
–
1
2