Brocade Network Advisor IP User Manual v12.3.0 - Manual (Page 662)

610 Brocade Network Advisor IP User Manual
53-1003153-01
DCB configuration
17
• The Add LAG button on the DCB Configuration dialog box is enabled when a single DCB switch
or ports of a single DCB switch are selected.
• The Add LAG button is disabled when multiple switches are selected, ports from different
switches are selected, or LAGs are selected.
• The Edit LAG button is enabled when a single LAG, port, or switch is selected.
Creating a LAG is not supported for Network OS products. You must use the command line
interface to configure a LAG for Network OS products. Refer to the Network OS Command
Reference for more information.
NOTE
When LLDP-DCBX is disabled on the switch, a yellow banner displays on the DCB Configuration
dialog box, indicating that LLDP-DCBX is not only disabled on the switch, but is also disabled for all
ports and LAGs on the switch.
1. Select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select the DCB switch or one or more DCB ports from the Products/Ports list to add to a link
aggregation group (LAG).
3. Click Add LAG or Edit LAG.
The Add LAG or Edit LAG dialog box displays, as shown in Figure 243 .
FIGURE 243 Add LAG dialog box
4. Configure the following LAG parameters:
NOTE
Ports with 802.1x authentication or ports that are enabled in L2 mode or L3 mode are not
supported in a LAG.