Raslog events – Brocade Network Advisor IP User Manual v12.3.0 User Manual

Page 928

Advertising
background image

876

Brocade Network Advisor IP User Manual

53-1003153-01

Change tracking

24

NOTE

The Adaptive backup type is supported only on the Network OS devices; it is not supported
on the IronWare devices.

-

Startup Config Change Trap — Occurs when a startup configuration is changed.

-

Re-sync — Occurs when a trap is generated by the device during a startup or running
configuration change, or when a user performs a manual resynchronization of the device
For Network OS devices, Re-sync backup occurs after manual rediscovery of the VCS
cluster member device and when a CLI configuration deployment occurs on the product.

-

Manual — Occurs when a user clicks the Save Running/Startup Configuration button.

-

Scheduled — Occurs when backups are obtained as the scheduled times.

4. Perform one of the following actions:

•

Click the Refresh button to update the network and retrieve the latest data from the
database.

•

Click the View button to compare the contents of the latest configuration and the baseline
configuration. You can view only one configuration at a time.

•

Click the Export button to export the currently viewed change tracking records to a .csv file.
The default file name is “Change_Tracking_Report.csv.”

5. Click OK to save the configuration.

6. Click Cancel to exit the dialog box.

•

RASLog events

Table 86

shows the supported events for Adaptive backup on Network OS devices.

TABLE 86

Configuration change events for Adaptive backup

Message ID

Type

Description

AG-1006

LOG

Access Gateway mode has been enabled or disabled.

AG-1020

LOG

Indicates that VF_Port-to-N_Port mapping has been changed because the
switch has come online or some new N_Port or VF_Port has come online.

AG-1041

LOG

Information that the specified port group has been deleted.

DCM-1001

LOG

Indicates that the VCS ID has been changed.

DCM-1009

LOG

Indicates that the RBridge ID has changed to the specified value.

DCM-1011

LOG

Indicates that the VCS mode has been enabled.

DCM-1012

LOG

Indicates that the VCS mode has been disabled.

DCM-1105

LOG

Indicates that the downloaded configuration file has been copied to the
current running configuration.

ELD-1001

LOG

Indicates that a loop has been detected by the Edge Loop Detection (ELD)
protocol on the specified interface. The interface has been shut down.

ELD-1002

LOG

Indicates that the interface on which a loop was detected has been
auto-enabled based on the configured shutdown time.

ESS-1008

LOG

Indicates that the specified fabric name has been configured or renamed.

Advertising