Elitegroup G732 (V2.0) - Manual (Page 70)

Set Supervisor Password
This field allows you to set the Supervisor password. To set the Supervisor
password, highlight this field and press the [Enter] key. The following dialog box
appears:
Set Supervisor Password
Enter New Password [ ]
Confirm New
Password
[ ]
Type the password and press the [Enter] key. You can type up to seven
alphanumeric characters. Symbols and other keys are ignored. To confirm the
password, type the password again and press the [Enter] key. The Supervisor
password is now set. This password allows full access to the BIOS Setup menus.
To clear a password, highlight this field and press the [Enter] key. The same dialog
box as above will appear. Press the [Enter] key twice. The password is now cleared.
Set User Password
This field allows you to set the User password. To set the User password, follow the
same instructions for setting the Supervisor password. The User password allows
restricted access to the Setup menus.
This password also requires that the Supervisor password be set prior to setting the
User password.
Diskette Access
This option requires prior setting of the Supervisor password to function. When set
to User, the system will then require either the Supervisor or User password before
allowing access to the Floppy Disk Drive (FDD). When set to Supervisor, only the
Supervisor password will allow access to the FDD. The options for this field are:
User (default value), Supervisor
58