Nature Power Hanging Solar Shed Light (21030 ) - Manual

1
Hanging Solar Shed Light
With Remote Control
21030
Instruction Manual
Assembly Instructions
Solar panel installations
* Make sure to mount the solar panel no more than 15 Feet or 5 Meters
from the Hanging Solar Shed Light (the length of the wire provided)*
(There are two ways to assemble the Solar Panel.)
Pillar Mounted
1) Carefully remove all the fittings from the box
2) Setting the “L” Shape Screw (1) to solar panel (8) with PA3*15 Screw (4).
(shown in figure 1)
3) Connect “L” Shape Screw and Bracket for solar panel (6) and “U” Shape Screw (5). (AS shown in figure 2)
4) Tumble in the “L” Shape Screw to Pillar and twist the “U” Shape Screw tightly. (AS shown in figure 3)
Wall or Deck Mounted
1) Choose the wall or deck which you want to mounted the solar panel. Use the 4 holes of the bracket to aling the inflatable
capsules. (7) (as shown in figure 4).
2) Fit the Bracket with the Solar panel with provided PA3*15 Screw. (As shown in figure 5)
3) Set the Bracket on the wall or deck with 4Pcs provided PA4*35 Screws (9). (As shown in figure 6)
4) Adjust the angle of Solar Panel to make sure it receives optimal sunlight during the day.
Lamp installations
Use the 2 Pre-drill holes on the ceiling bracket, and mark the location. Then install the
2 inflatable screws. into the holes and attach the ceiling bracket with the 2 screws.
Connection of the Solar Panel and Lamp
Insert the plug of the Wires into the socket at the side of the ceiling bracket.