Nature Power Solar Pavilion Light (21035 ) - Manual

Version 1.1
1
Solar Pavilion Light
Owner’s Manual
Product Description
Add a bright light to tents, umbrellas, gazebos, pavilions, sheds, outbuildings and more.
The 3 LED bulb can last up to 8 hours on a full charge.
Item Number: 21035
Assembly (See Fig 1)
1. To attach your Solar Pavilion Light in your desired location unscrew the 2 plastic screws on the underside
of the Solar Panel. This will release 1 side of the clamp.
2. Slide the clamp under a fabric surface to mount. E.g. Umbrella, Awning, Gazebo, Shed etc.
3. Insert the 2 plastic screws back into the clamp and bring in the fabric from underneath to secure the solar
panel.
4. Ensure the Solar Panel is in an area with good quality sunlight and is not being obstructed from the sun.
5. String the solar light through to hang in desired location.
Operation (See Fig 2)
1. Once the solar panel is set in place leave it to charge for at least 2 days with the light tuned Off.
2. After the light has been left to charged for two days. Depress the
‘On/Off’ button on the light.
3. When the button is pressed down it will click in the ‘On’ position and
when the button is pressed out it will be in the ‘Off’ position.
4. Thread the wire though the hook provided to hang light at the desired
level.
Troubleshooting
If Solar Pavilion Light does not illuminate while switch is turned to ‘On’ please
observe the following.

Ensure the solar panel is in a location where it will receive maximum
sunlight during daytime hours.

Check batteries are installed correctly.

Allow Panel to charge in direct sunlight for 2 days with the switch in the
‘Off’ Position to confirm the batteries are fully charged.

Replace Batteries.
Note: The batteries may be dead and need replacing. Although rechargeable, the batteries included in this unit
have a limited lifetime.