Seca 376 - Manual (Page 45)

Operation • 45
English
Continuous display of
measured result (HOLD)
If you activate the HOLD function, the weighing value
will continue to be displayed after the baby has been
removed. This allows you to attend to the child before
noting down the weight.
1. Place the baby on the scales.
2. Briefly press the arrow key (hold/tare).
The display will flash until a stable weight is meas-
ured. The weighing value will then be displayed
continuously. The
symbol (non-calibratable func-
tion) and the message "HOLD" will be displayed.
3. To disable the HOLD function, briefly press the
arrow key (hold/tare).
The
symbol and the message "HOLD" will no
longer be displayed.
NOTE:
If the Autohold function is activated, continuous
display of the weighing value will take place
automatically. see "Activate Autohold function
(Ahold)" on page 48.
Transmit measured
results to a radio
receiver
If the scales are integrated in a seca 360° wireless net-
work, you can transmit the measured results to
receive-ready equipment (wireless printer, PC with
wireless USB module) at the touch of a button.
♦ Press the Enter key (send/print).
– Press key briefly: Send measured results to
all receive-ready equipment
– Hold down: Print out measured result using
wireless printer
Automatic switchover
of weighing range
The scales are equipped with two weighing ranges.
Weighing range 1 (
) offers a more precise weight
indication with a reduced load-bearing capacity.
Weighing range 2 (
) allows you to take advantage
of the maximum load-bearing capacity of the scales.
When the scales are switched on, weighing range 1 is
activated. If a specific weighing value is exceeded, the
scales will automatically switch to weighing range 2.
To switch back to weighing range 1 proceed as
follows:
♦ Remove all loads on the scales.
Weighing range 1 is activated again.
hold
tare
hold
tare
send
print