Seca 376 - Manual (Page 50)

50 •
NOTE:
The wireless module is switched off when
restoring the factory settings. Data for existing
wireless groups remains in the memory. These
groups do not need to be set up again.
1. Select the item "Reset" in the menu.
2. Confirm the selection.
You will leave the menu automatically.
3. Switch the scales off.
The factory settings are restored and will be availa-
ble when the scales are next switched on.
7. SECA 360° WIRELESS NETWORK
7.1 Introduction
This device is equipped with a wireless module. The
wireless module allows measured results to be trans-
mitted wirelessly for analysis and documentation. Data
can be transmitted to the following equipment devices:
• seca wireless printer
• PC with seca USB wireless module
seca wireless groups The seca 360° wireless network operates with wireless
groups. A wireless group is a virtual group of transmit-
ters and receivers. If you wish to operate several trans-
mitters and receivers of the same type, up to 3 wireless
groups (0, 1, 2) can be set up with this device.
The set-up of several wireless groups ensures the relia-
ble transmission of measured values with the correct
address when using more than one examination room
each with similar equipment.
The maximum distance between transmitters and
receivers is approx. 10 metres. This range may be
reduced under certain local conditions, e.g. thickness
and type of wall partitions.
1
0