Seca 704 - Manual (Page 53)

Operation • 53
English
5. To change your selection or call up another sub-
menu, keep pressing one of the arrow keys until the
required selection is displayed (here: level "2").
6. Confirm the selection with the Enter key (send/
print).
You will leave the menu automatically.
7. To make further selections, call up the menu again
and proceed as described above.
NOTE:
If no key is pressed for approx. 24 seconds, you
will leave the menu automatically.
Clear stored values
automatically (AClr)
To avoid storing obsolete measured results in the
device memory and so calculating the BMI incorrectly,
you can set the scales to ensure measured values are
automatically cleared after 5 minutes.
NOTE:
With certain models this function is already acti-
vated at the factory. If required, you can disable
this function.
1. Select the item "AClr" in the menu.
2. Confirm the selection.
3. Select the setting you require:
– On
– Off
4. Confirm the selection.
You will leave the menu automatically.
Permanently store
additional weight (Pt)
You can use the Pre-Tare function to permanently store
an additional weight and automatically deduct it from
the measured result. You can for example store a flat-
rate figure as the weight of shoes and clothing and then
always deduct it from the measured result when a
patient is weighed fully dressed.
1. Select the item "Pt" in the menu.
The message "Pt" appears.
2. Confirm your selection.
Arrows can be seen flashing in the display.
The additional weight last stored is displayed.
3. You can accept the stored value or adjust it using
the arrow keys.