Seca 704 - Manual (Page 60)

60 •
10. Confirm your selection for channel 3.
The message
StOp
appears in the display.
The device is waiting for signals from other equip-
ment devices with radio transmission capability
within its range.
NOTE:
With certain devices a special switch-on proce-
dure has to be followed if they are to be inte-
grated in a wireless group. Consult the user
manual for each device.
11. Switch on the equipment device you wish to inte-
grate in the wireless group, e.g. wireless printer.
A beep will be heard when the wireless printer is
detected.
NOTE:
As soon as you have integrated a wireless
printer in the wireless group, you have to select
a print option (menu\rf\APrt) and set the time
(menu\rf\time).
12. Repeat step 11. for all equipment devices you wish
to integrate in the wireless group.
13. Press the Enter key to end the search.
14. Press one of the arrow keys to see which devices
have been detected (here: Mo 3 for a wireless print-
er).
Once you have integrated several devices in the
wireless group, press the arrow keys several times
to check that all equipment has been detected by
the scales.
15. Press the Enter key to leave the menu or wait until
you leave the menu automatically.
Activate automatic
transmission (ASend)
You can configure the device so that the measured
results are automatically transmitted to all receivers that
are ready to receive and logged into the same wireless
group (e.g.: wireless printer, PC with USB wireless
module).
NOTE:
If you are using a wireless printer, ensure that
“off” is not set as a print option (see "Select
print option (APrt)" on page 61).
1. Switch the device on.