Triton RL2000 User Manual - Manual (Page 37)

33
G ENERAL M AINTENANCE
5. Remove the tab securing the end of the new paper roll to itself. Use scissors to cut off all of the paper
up to and including the glue tab.
Remove the plastic spindle from the old paper roll and insert into the new roll of paper . Use a 4-inch roll
of 60 mm or 80 mm wide thermal paper, printer applicable
Be sure the spindle is inserted so that the paper will feed from the
TOP
of the roll when it is installed on
the paper bracket.
6. Place the new roll back on the paper bracket by sliding the small, slotted end of the spindle onto the slot
in the bracket as shown. Note that the paper feeds from the TOP of the roll!
3. Use the receipt printer feed button to feed the paper through the paper path until all paper comes out
the front of the printer.
Paper feed button location.
4. Remove the paper and spool from the paper bracket.
Remove paper roll from bracket.
Place paper roll on bracket. Paper feeds from top of roll!