Triton RL2000 User Manual - Manual (Page 98)

153 Electronic journal mode 1. Inspect main board to electronic journal communication cable for
damage. Make sure the connectors are seated securely on the main
board and on the electronic journal.
2. If it is necessary to check continuity of the cable assembly, refer
to Appendix B for pin out of the cable assembly.
3. Inspect electronic journal to dispenser communication cable for
damage. Make sure the connectors are seated securely on the main
board and on the electronic journal.
4. If it is necessary to check continuity of the cable assembly, refer
to Appendix B for pin out of the cable assembly
5. If the cables are undamaged, the main board or electronic
journal may be defective.
154 Unknown electronic journal status 1. Inspect main board to electronic journal communication cable for
damage. Make sure the connectors are seated securely on the main
board and on the electronic journal.
2. If it is necessary to check continuity of the cable assembly, refer
to the appropriate ATM Service Manual for pin out of the cable
assembly.
3. Inspect electronic journal to dispenser communication cable for
damage. Make sure the connectors are seated securely on the main
board and on the electronic journal.
4. If it is necessary to check continuity of the cable assembly, refer
to the appropriate ATM Service Manual for pin out of the cable
assembly
5. If the cables are undamaged, the main board or electronic
journal may be defective.
155 Electronic journal modify record
failure 1. Inspect main board to electronic journal communication cable for
damage. Make sure the connectors are seated securely on the main
board and on the electronic journal. 2. If it is necessary to check
continuity of the cable assembly, refer to Appendix B for pin out of
the cable assembly. 3. Inspect electronic journal to dispenser
communication cable for damage. Make sure the connectors are
seated securely on the main board and on the electronic journal.4.
If it is necessary to check continuity of the cable assembly, refer to
Appendix B for pin out of the cable assembly 5. If the cables are
undamaged, the main board or electronic journal may be defective.
156 Cassette out of service. This occurs when the last cassette has been taken out of service.
Cassettes are taken out of service because of feed failures or
excessive rejects.
1. Inspect cassettes. Fill if needed. If they are not empty, see
corrective action for Error Code 33.
2. If excessive rejects are suspected, see corrective action for Error
Code 48.
3. Place cassettes in service.
157 Erase command to electronic
journal failed 1. Inspect main board to electronic journal communication cable for
damage. Make sure the connectors are seated securely on the main
board and on the electronic journal.
2. If it is necessary to check continuity of the cable assembly, refer
to the appropriate ATM Service Manual for pin out of the cable
assembly.
3. Inspect electronic journal to dispenser communication cable for
damage. Make sure the connectors are seated securely on the main
board and on the electronic journal.
4. If it is necessary to check continuity of the cable assembly, refer
to the appropriate ATM Service Manual for pin out of the cable
assembly
5. If the cables are undamaged, the main board or electronic
journal may be defective.
15