Delmhorst Instrument TotalCheck - Manual (Page 10)

Copyright  2006, Delmhorst Instrument Co.
Page 10 of 32
2. You may begin taking readings by firmly pressing the back of the meter onto
the material. This will display a relative reading that ranges between 0 and 300.
TO SET THE ALARM IN BASIC SCAN MODE:
1. If you wish to set the alarm to beep after a pre-selected relative value is
reached, use the  keys from the SCAN screen to highlight the ALARM.
Press the SELECT key to enter the alarm sub menu.
2.
The default status of the alarm is “OFF.” Press the SELECT key to turn it on.
3. After the alarm is turned on, use the  keys to scroll up or down to a
higher or lower alarm value.
4. After you have selected the alarm value, use the  key to highlight DONE.
Press SELECT to get back to the SCAN screen.
Note: Default alarm settings for SCAN mode is 300.
TO TAKE TEMP/RH READINGS IN BASIC MODE:
Before entering the RH-T mode, firmly insert the RH/T-S1 sensor into the top of the
meter, making sure to align the pin-out on the DIN connector.
1. From the BASIC Main Menu, use the  key to highlight RH-T MODE.
Then, press the SELECT key to get into the RH-T mode main menu.
The meter will display the main RH-T mode main menu, as shown below:
2. The meter will begin taking readings. As a default setting the RH reading will
be the most prominent on the screen. If you would like to make another variable
(temperature, GPP/GPK or dew point), the prominent reading , use the
 and  keys to highlight your selection. Press the SELECT key to
choose that variable.