Delmhorst Instrument TotalCheck - Manual (Page 14)

Copyright  2006, Delmhorst Instrument Co.
Page 14 of 32
This screen contains the following information: material, pin setting, temperature
correction, Job #, alarm setting, mode, and memory used.
3. Insert the pins into the material. The meter will start taking measurements in
one of the two following ways, depending on whether it is set for CONTINUOUS
or TRIGGERED mode. To choose between TRIGGERED or CONTINUOUS, use
the
 and  keys to highlight MODE, and then press the SELECT key to
toggle between TRIG and CONT.

When the meter is set to Triggered mode, a single reading is taken
every time the SELECT button is pressed. Each reading is stored in
memory. The last measurement remains displayed on the screen.

When the meter is set to Continuous mode, press SELECT key to
initiate the reading cycle. The meter keeps taking MC readings in this
mode. These readings are NOT stored until the SELECT key is pressed
again. To exit continuous mode WITHOUT STORING the current reading,
press any directional key ( and ).
To exit continuous mode
and STORE the current reading, press the SELECT key. Exiting
continuous mode leaves the last reading on the screen. To resume
continuous mode, press the SELECT key again. Use the
 and
 keys to choose a different option.
4. At any time, you may modify Temperature (T).
The EXIT option in both SCAN and PIN MODE menus will cancel the
measurement process and will put the meter in the MAIN MENU.
TO TAKE SCAN READINGS IN ENHANCED MODE:
1. In the MAIN Menu, highlight option #2: SCAN
The screen will look as follows: