Delmhorst Instrument TotalCheck - Manual (Page 19)

Copyright  2006, Delmhorst Instrument Co.
Page 19 of 32
in the selected job. If left unchanged, the first reading to be reviewed will be number 1.
Readings may only be reviewed in ascending sequential order.
Using the

keys, the left-side value can be changed in increments of 10. For
example, assume the selected job contains 23 readings. The View Set entry will begin by
displaying “1 TO 23”. Successive Right button
presses will yield the following: “11 TO 23”
and “21 TO 23”. At this point, the value on the left side is within 10 readings of the value
on the right side. Alternately, pressing the Left button causes the meter to subtract 10
from the current left-side value.
o DONE: Selecting this option signals to the meter that the user has completed the reading
recall setup process and is ready to begin reviewing readings.
NOTE: There may be a significant delay while the meter processes the required set of readings
for review, depending on the number of jobs present in the meter, percentage of memory space
occupied by readings, current job size and fragmentation. The meter will display a screen with the
word “PROCESSING…”. User input is ignored during this time. Control is returned to the user
once the algorithm is complete and the Retrieved Readings screen is displayed, as shown in the
example above:
o
CANCEL: This feature returns the meter to the Storage Menu

CLEAR MEMORY:
This option will delete all the readings stored in the meter, but will keep the
defined job structures and associated locations and areas in tact.

RESTORE DEFAULTS:
This will delete all defined parameters and readings stored in the meter. The
meter will be now set to the factory parameters: T = 70F, Non-insulated probe,
Backlight = OFF, Power-off time = 2 min.
Note: Memory deletion and restoring defaults are both irreversible.
EXIT: This menu option returns the meter to Main Menu.