GW Instek GSP-830 User Manual - Manual (Page 127)

SYSTEM
127
4. Connect a 9-pin male RS-232C
cable to the rear panel
connector.
GPIB
configuration
(optional) The GPIB interface is a factory installed optional item.
Contact service personnel for a new installation.
1. Press the System key.
System
2. Press F2 (GPIB Add).
GPIB Add
8
F 2
3. Select GPIB address using the
Left/Right keys, Scroll knob, or
Numerical keys. Configure the
PC according to this setting.
BK SP
GHz / Sec
mSec MHz /
kHz / Sec μ
4. Connect GPIB cable to the rear
panel terminal.
Check GPIB installation status
1. To check the GPIB installation
status, press the System key.
System
2. Press F6 (More).
More... F 6
3. Press F4 (System Config On).
System Config
On Off
F 4
4. The system configuration
appears. When the GPIB
module is installed correctly, the
check box is marked.
Installed
Uninstalled
Check GPIB self-test result
1. To check the internal GPIB
functionality result, press the
System key.
System
2. Press F6 (More).
More... F 6