GW Instek GSP-830 User Manual - Manual (Page 137)

SEQUENCE
137
Edit Sequence
1. Select
sequence
1. Press the Sequence key. The
display enters into the
sequence edit mode.
Seq
2. Press F1 (sequence 1 to 5) or
F2 (sequence 6 to 10)
repeatedly to select the
sequence ID.
Select Seq
6 7 8 9 10
F 2
Select Seq
1 2 3 4 5
F 1
2. Start editing 1. Press F3 (Edit).
Edit... F 3
2. Press F1 (Start Edit).
Start Edit F 1
3. The Start Edit sign in the
mid-right of the display turns
green.
Start Edit
2a. Add step 20 steps are available for each sequence. Every key
operation can be recorded as a step.
Press the Enter key each time to confirm step entering.
(In some cases this is not necessary: check if the item
appears in the window).
Example: Activate system auxiliary
signal
1. Press the System key.
2. Press F4 (Aux Sig On).
3. Press the Enter key.
System
Aux Sig
On Off
F 4
Example: Run Autoset
1. Press the Autoset key.
2. Press F1 (Autoset).
3. Press the Enter key. Autoset
Autoset F 1
The result looks like this. Aux Sig On
Autoset