GW Instek PEL-2000 Series User Manual - Manual (Page 118)

PEL-2000 Series User Manual
118
Editing CC /CR/CV A/B Value
Background The Selector Knob can be used to change the A
Value and B Value (single channel load module)
when in static mode.
Panel Operation 1. Ensure the mode is in static
mode.
Page 114
2. Choose a channel (or choose A
or B Value) by pressing the R/L
or A/B key.
3. Turn the Selector knob to edit
the A/B Value for the selected
mode.
Note
When the Slave Knob is set to “Measured”, the
selector knob must be pressed first to display the
values on the load module display.